Product Description
- (2) Spindles
- (1) Front Crossmember
- (1) Rear Crossmember
- (2) Compression Struts
- (1) Skid Plate
- (2) Differential Drop Brackets
- (2) CV Axle Spacers
- (2) Rear Bump Stop Extenders
- (2) Front Bump Stop Extenders
- (2) Torsion Bar Drop Brackets
- (4) Compression Strut Brackets
- (2) Lift Blocks w/ U-bolts & Hardware
- (2) Lower A-Frame Support Rods
- (1) Rear Brake Line Extender
- (1) Weld-in Filler Plate
- (2) Zinc Brackets w/ 2 Welded Nuts
- (2) Front Shocks
- (2) Rear Shocks
- Complete Hardware Package
Notes:
This kit can be adjusted to 8″ or 9″. You will need Torsion Keys #52100 (sold separately), to raise up the front. This will put the front of the vehicle higher than the rear. Unfortunately, we have no parts to add extra height to the rear.
If running this kit at the 9″ position, we highly recommend using Upper Control Arms #52151 (sold separately) to help with bump stop clearance issues
Over-sized tires and heavier wheels can cause premature wear on factory and aftermarket components like ball joints, bushings, tie-rod ends, wheel bearings, idlers arms, drive-lines, etc… You may need to replace / install new components sooner than factory recommendations based on the wheels and tires you choose. Please note that the heavier and wider wheels and tires combined with aggressive driving (off-road and on highways) will cause more wear on ALL moving parts, factory and aftermarket. Especially when vehicle is in 4wd or Auto-4wd / AWD modes.
Spindles and u-bolts are shipped with protective coating on surface. This allows them to be delivered to you without rust. We recommend you clean and paint the parts before you install, to protect against any future rust. Remember, spindles and u-bolts are bare metal. And will rust without paint.
